Gibson GCG91326XA Manual do Utilizador descarregar pdf (Página 23)

Adjustment to different types of gas

WARNING!

Let only an authorized person do

the adjustment to different types of

gas.

Check the table in chapter

"Product descriptions" to see the

initial gas of your appliance.

If the appliance is set for natural

gas you can change it to liquid gas,

with the correct injectors.

If the appliance is set for liquid gas

you can change it to natural gas,

with the correct injectors.

The gas rate is adjusted to suit.

WARNING!

Before you replace the injectors,

make sure that the gas knobs are

in the Off position. Disconnect the

appliance from the electrical

supply. Let the appliance cool

down. There is a risk of injury.

The appliance is set to default gas.

To change the setting choose a

pipe holder from the list. Always

use the gasket sealing.

A CB

A. Gas connection end

B. Natural Gas pipe holder

C. LPG pipe holder

Hob injectors replacement

Replace the injectors when you change the

gas type.

1. Remove the pan supports.

2. Remove the caps and crowns of the

burner.

3. Remove the injectors with a socket

spanner 7.

4. Replace injectors with the ones necessary

for the type of gas you use.

5. Replace the rating plate (it is near the gas

supply pipe) with the one for the new type

of gas supply.

You can find this plate in the

bag supplied with the

appliance.

If the supply gas pressure is not constant or it

is different from the necessary pressure,

install an applicable pressure adjuster on the

gas supply pipe.

Adjusting the minimum gas level on the

hob burner

1. Disconnect the appliance from the

electricity.

2. Remove the knob for the hob. If there is

no access to the bypass screw dismount

the control panel before adjustment start.

3. With a thin and flat screwdriver adjust the

bypass screw A.

The model determines the position of the

bypass screw A.

A A

Changing from natural gas to liquid

gas

1. Fully tighten the bypass screw.

2. Put the knob back.

Changing from liquid gas to natural

gas

1. Unscrew approximately one turn the

bypass screw position A.

2. Put the knob for the hob back.

3. Connect the appliance to the electricity.

23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Comentários a estes Manuais

Sem comentários