Gibson GCK95206XA Manual do Utilizador descarregar pdf (Página 22)

If the supply gas pressure is not constant or it

is different from the necessary pressure,

install an applicable pressure adjuster on the

gas supply pipe.

Adjusting the minimum gas level on the

hob burner

1. Disconnect the appliance from the

electricity.

2. Remove the knob for the hob. If there is

no access to the bypass screw dismount

the control panel before adjustment start.

3. With a thin and flat screwdriver adjust the

bypass screw A.

The model determines the position of the

bypass screw A.

A A

Changing from natural gas to liquid

gas

1. Fully tighten the bypass screw.

2. Put the knob back.

Changing from liquid gas to natural

gas

1. Unscrew approximately one turn the

bypass screw position A.

2. Put the knob for the hob back.

3. Connect the appliance to the electricity.

WARNING!

Put the mains plug into the

mains socket only if all parts

are back into their initial

position. There is a risk of

injury.

4. Light the burner.

Refer to "Hob - Daily use" chapter.

5. Turn the knob for the hob to the minimum

position.

6. Remove the knob for the hob again.

7. Screw on slowly the bypass screw till the

flame becomes minimum and stable.

8. Put the knob for the hob back on.

Levelling

CAUTION!

Remove all the accessories from

the oven.

1. Open the lid of the appliance and

disassemble the lid, the pan supports and

all the burner assemblies.

2. Put the appliance on the sidewall on a

clean and smooth surface. Place each

foot into a separate hole, in the plinth, and

rotate it counterclockwise.

B

3. If the floor is not equally flat, use the

adjustable feet on the bottom of the

appliance to set a stable position for the

appliance.

22

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Comentários a estes Manuais

Sem comentários